Hyundai Creta Oil Capacity & Oil Type
TL;DR
Capacity depends heavily on which engine your Creta has - 1.6L, 2.0L, or the newer 1.0L turbo - not just the model year, so match your engine code before adding oil.
Why the engine code matters more than the model year
Hyundai sold the Creta in Latin America with at least three different engine families: the 1.6L Gamma (engine codes G4FC and G4FG depending on market), the 2.0L Nu (G4NA and the flex-fuel G4NB used in Brazil), and the newer 1.0L T-GDI turbo (Kappa, engine code G3LC) introduced with the second-generation, Brazil-built Creta from 2021 onward. These do not share a fill capacity, so a figure for one engine should never be applied to another just because the badge says Creta.
Verified capacity and viscosity by engine
The table below lists only the figures found in at least one credible source per engine code. Where sources disagreed, a range is shown instead of a single invented number.
| Engine code / years | Capacity with filter (L / US qt) | Viscosity |
|---|---|---|
| 1.6L Gamma - G4FC / G4FG (approx. 2016-2021) | 3.6 L / 3.8 US qt | 5W-20 or 5W-30 (API SN or higher) |
| 2.0L Nu - G4NA / G4NB flex (approx. 2016-present) | 4.0-4.2 L / 4.2-4.4 US qt (sources vary) | 5W-20 or 5W-30 (API SN/SP) |
| 1.0L T-GDI turbo - Kappa G3LC (2021-present, 2nd gen) | 3.3-3.6 L / 3.5-3.8 US qt (sources vary) | 0W-20 or 5W-30 synthetic (API SP) |
Where to get the exact number for your car
Because published figures can vary by trim, market calibration, and running production changes, always confirm against your own vehicle before an oil change:
- The owner's manual maintenance/lubricants section for your specific engine code
- The oil filler cap, which is often stamped with the recommended viscosity
- A Hyundai dealer or service center, who can look up the exact build spec by VIN
A note on the driver's door placard
The driver's door jamb placard on most vehicles lists tire pressure and payload information rather than oil capacity - for oil, the filler cap and owner's manual are the correct references, not the door placard.
Summary
| Primary market covered | Brazil / Latin America |
|---|---|
| 1.6L Gamma (G4FC/G4FG) capacity | 3.6 L (3.8 US qt) with filter |
| 2.0L Nu (G4NA/G4NB) capacity | 4.0-4.2 L (4.2-4.4 US qt) with filter |
| 1.0L T-GDI turbo (G3LC) capacity | 3.3-3.6 L (3.5-3.8 US qt) with filter |
| Common viscosity, naturally aspirated | 5W-20 or 5W-30 |
| Common viscosity, 1.0 turbo | 0W-20 or 5W-30 synthetic |
| Authoritative source for your car | Owner's manual + oil filler cap, matched to your engine code |
Full diagnostics
For the complete step-by-step diagnostic and repair guide, see Hyundai Creta: Common Problems, Fault Codes & Repairs.
Frequently asked questions
Does the Hyundai Creta 1.6 and 2.0 take the same amount of oil?
No. The 1.6L Gamma engine (G4FC/G4FG) takes about 3.6 L (3.8 US qt) with filter, while the 2.0L Nu engine (G4NA/G4NB) takes about 4.0-4.2 L (4.2-4.4 US qt) with filter. Always match the figure to your engine code, found on a sticker under the hood or in your owner's manual.
What oil viscosity does the Creta 1.0 turbo need?
The 1.0L T-GDI Kappa turbo engine (G3LC), used in the second-generation Brazil-built Creta from 2021 onward, calls for a synthetic 0W-20 or 5W-30 oil meeting API SP, per manufacturer and service-data sources. Confirm the exact grade on your oil filler cap or in the owner's manual, since turbocharged engines are less tolerant of the wrong viscosity.
Why do different websites give different capacity numbers for the same Creta?
Capacity figures can vary between the international Nu engine code (G4NA) and the Brazil flex-fuel variant (G4NB), and different service databases sometimes round differently or measure dry versus service fill. When sources disagree, treat the number as an approximate range and verify with a dipstick check after refilling rather than trusting a single online figure.
Where is the definitive source for my specific Creta's oil capacity?
Your own owner's manual, matched to your engine code, is the definitive source, since it reflects the exact calibration Hyundai used for your VIN. The oil filler cap also usually shows the recommended viscosity. Online databases are useful for cross-checking but should not override what your manual and vehicle say.