Renault Sandero Oil Capacity & Oil Type

Quick answer: This guide focuses on the Brazil / Latin American Renault Sandero. Figures differ by engine code, not just by model year: the widely used 1.6 16V K4M engine (Sandero I and II, roughly 2007-2020) takes about 4.8 L (5.1 US qt) with filter, while the 1.0 16V D4D engine takes about 4.0 L (4.2 US qt) and the 1.6 8V K7M engine about 3.3 L (3.5 US qt). For the current 1.0 12V (B4D/H4D SCe) engine sold since 2014, published aftermarket figures were inconsistent, so no exact number is stated here - check your filler cap or owner's manual instead.

TL;DR

Oil capacity on the Sandero depends on the engine code (K7M, D4D, K4M, B4D/H4D), not just the model year - figures below are per engine, ranging roughly 3.3 to 4.8 L with filter.

Renault Sandero engine oil capacity (Brazil / Latin America)

This page treats the Brazil-built and Latin-American-market Renault Sandero as the primary subject, since it is the version most readers searching this model are driving. The Sandero was sold there with several distinct engine families over the years, and oil capacity is tied to the engine code, not simply the model year or trim name - two Sanderos from the same generation can carry different engines with different capacities.

Verified figures by engine code

The figures below were cross-checked across independent oil-capacity references. Where a figure could not be reliably corroborated, it has been left out rather than guessed.

Engine code / yearsCapacity with filter (L / US qt)Viscosity
K7M 1.6 8V (Sandero I, circa 2007-2015)3.3 L / 3.5 qt5W-30 or 10W-40 (Renault RN0700/RN0710 spec)
D4D 1.0 16V (Sandero I and early Sandero II, circa 2007-2017)4.0 L / 4.2 qt5W-30 (Renault RN0700/RN0710 spec)
K4M 1.6 16V (Sandero I and II, circa 2007-2020)4.8 L / 5.1 qt5W-30 or 10W-40 (Renault RN0700/RN0710 spec)
B4D / H4D 1.0 12V SCe (Sandero II and III, 2014-present, main Brazil engine)Not independently confirmed - reported figures ranged 3.0-3.5 L across sourcesTypically 5W-30 synthetic per Renault spec; confirm on your filler cap

Why this matters

Overfilling or underfilling by even half a liter can cause aeration, oil starvation, or seal leaks. Because the current 1.0 SCe engine's exact capacity could not be confirmed across sources with confidence, do not rely on a number pulled from memory for that engine - use the dipstick and add oil gradually while checking the level.

Always confirm on your own vehicle

Engine specifications can change mid-production run, and regional versions vary. Before topping up or doing an oil change, confirm the exact figure for your car using one of these authoritative sources:

  • The oil filler cap, which is often stamped with the viscosity grade
  • Your owner's manual maintenance or fluids section
  • The driver's door placard, which sometimes references fluid specs
  • A Renault dealer or authorized service center, quoting your chassis (VIN) number

Summary

Primary market coveredBrazil / Latin America
K7M 1.6 8V capacity (with filter)3.3 L (3.5 US qt)
D4D 1.0 16V capacity (with filter)4.0 L (4.2 US qt)
K4M 1.6 16V capacity (with filter)4.8 L (5.1 US qt)
B4D/H4D 1.0 SCe capacityNot independently confirmed - check filler cap
Typical viscosity (older engines)5W-30 or 10W-40, RN0700/RN0710
Authoritative source for your carOwner's manual and oil filler cap

Full diagnostics

For the complete step-by-step diagnostic and repair guide, see Renault Sandero: Common Problems, Fault Codes & Repairs.

Frequently asked questions

Does the Sandero take the same amount of oil regardless of engine?

No. Capacity depends on the engine code fitted to that specific car, not the model year alone. On the Brazil/Latin America Sandero, confirmed figures range from about 3.3 L for the K7M 1.6 8V up to about 4.8 L for the K4M 1.6 16V, both with filter.

What oil viscosity does the Renault Sandero need?

Older K7M, D4D, and K4M engines are approved for 5W-30 or 10W-40 oil meeting Renault's RN0700 or RN0710 specification. The current 1.0 SCe engine typically calls for a 5W-30 synthetic oil, but you should confirm the exact grade stamped on your filler cap or listed in your owner's manual.

Why isn't there an exact oil capacity listed for the 1.0 SCe (B4D/H4D) engine?

Available reference sources gave inconsistent figures for this engine (roughly 3.0 to 3.5 L), so rather than repeat an unverified number, this page tells you to check the engine oil dipstick, filler cap markings, or your owner's manual, which will state the exact figure for your specific car.

Where is the most reliable place to find my exact Sandero's oil capacity?

Your owner's manual (in the maintenance or capacities section) and the oil filler cap are the most reliable sources, since they reflect the exact engine and production spec installed in your car rather than a general model average.

Where the binding figure is on your car

The figures on this page are per-generation references compiled from manufacturer documentation and established fitment databases. Where your own vehicle disagrees with them, your vehicle is right.