Toyota Tacoma Tire Pressure (Recommended PSI)
TL;DR
There is no single universal PSI for the Tacoma - pressure depends on generation, trim, and factory tire size, so check your driver's door jamb placard for the exact front and rear numbers.
Why there is no single Tacoma tire pressure number
The Toyota Tacoma has been built across four generations with many trims and at least three different factory tire sizes per generation. Toyota sets the recommended cold inflation pressure to match each tire size and load rating, so a truck with 265/70R16 tires can call for a different pressure than the same-year truck with 245/75R16 or 265/60R18 tires. Any page claiming one PSI figure fits every Tacoma is oversimplifying.
What we could verify
For the 2nd generation (2005-2015), multiple sources agree on 29 psi front and rear as the standard factory figure. For the 3rd generation (2016-2023), a documented 2019 placard breakdown shows SR and SR5 trims at 32 psi, Limited and TRD Sport at 29 psi, and TRD Off-Road and TRD Pro at 30 psi (front and rear on all three). For the redesigned 4th generation (2024+), owner and forum reports describe two placard groups: Type A and Type B trucks at 35 psi, and Type C trucks (wider 265/70R17 tire, higher load rating) at 30 psi - this pattern was less consistently confirmed across independent sources, so treat it as a strong lead rather than a certainty until you check your own placard.
Where to find your exact number
The only fully authoritative source for your truck is the tire and loading information placard on the driver's door jamb (open the door and look at the pillar). It lists the original-equipment tire size and the exact cold front and rear PSI Toyota engineered for your specific configuration. Your owner's manual repeats the same figures and explains cold-inflation procedure.
General guidance
- Always measure pressure when tires are cold (vehicle parked 3+ hours, or driven less than a mile).
- The number molded into the tire's sidewall is the tire's maximum pressure rating, not Toyota's recommended pressure - do not inflate to that figure.
- If you change to a non-factory tire size or add a lift kit and larger tires, the placard figure may no longer be optimal; consult the tire manufacturer's load chart.
- A TPMS low-pressure warning threshold (sometimes shown as 35 psi in the dash) is not the same as the recommended placard pressure - do not treat the warning threshold as your target.
| Generation / years | Trim or tire size | Front (PSI) | Rear (PSI) |
|---|---|---|---|
| 2nd gen (2005-2015) | All standard trims | 29 | 29 |
| 3rd gen (2016-2023) | SR / SR5 (245/75R16) | 32 | 32 |
| 3rd gen (2016-2023) | Limited / TRD Sport | 29 | 29 |
| 3rd gen (2016-2023) | TRD Off-Road / TRD Pro (265/70R16) | 30 | 30 |
| 4th gen (2024+) | Type A / Type B (per forum reports) | 35 | 35 |
| 4th gen (2024+) | Type C, wider 265/70R17 (per forum reports) | 30 | 30 |
Summary
| 2nd gen (2005-2015) front/rear | 29 / 29 psi |
|---|---|
| 3rd gen SR/SR5 front/rear | 32 / 32 psi |
| 3rd gen Limited/TRD Sport front/rear | 29 / 29 psi |
| 3rd gen TRD Off-Road/Pro front/rear | 30 / 30 psi |
| 4th gen Type A/B (reported) | 35 / 35 psi |
| 4th gen Type C (reported) | 30 / 30 psi |
| Authoritative source | Driver's door jamb placard |
Full diagnostics
For the complete step-by-step diagnostic and repair guide, see Toyota Tacoma: Common Problems, Fault Codes & Repairs.
Frequently asked questions
Is Tacoma tire pressure the same on the front and rear?
In every generation we could verify, Toyota sets the same cold PSI for front and rear on the Tacoma (unlike many other trucks with a heavier rear-biased spec), but you should still confirm both numbers on your own door placard since payload and towing can change the rear figure Toyota recommends when loaded.
Why do people say their Tacoma placard shows 35 psi?
On some 4th-generation (2024+) trucks with the Type A or Type B tire option, owner and forum reports describe a 35 psi placard figure, while trucks with the wider Type C tire show 30 psi. This is a real per-configuration difference in tire load rating, not a printing error, but confirm it on your own placard since it was not corroborated across multiple independent manufacturer sources.
My dealer filled my tires to 36 psi - is that wrong?
Dealers sometimes over-inflate for transport or storage. If your driver's door placard specifies a lower figure (commonly 29-32 psi depending on generation and trim), bleed the tires down to that cold reading using a manual gauge rather than trusting the as-delivered pressure.
Where exactly is the tire pressure placard on a Tacoma?
Open the driver's door fully and look at the door jamb or the vertical pillar the door latches against - the placard is a sticker there listing tire size, maximum load, and the recommended cold front and rear PSI. It is the single most reliable source for your exact truck, ahead of any general guide including this one.